![]() ![]() The GCode can originate from a number of sources: ¶ GCode and RepRapFirmwareĪ typical piece of GCode sent to a machine running RepRapFirmware might look like this (The meaning of these codes (and more) is explained below on this page.)Ī design philosophy of RepRapFirmware is "GCode everywhere" what this means is explained in this sub section More details can be found on the GCodes not implemented page. There are some GCodes listed on that page that are not implemented in RepRapFirmware. ![]() RepRapFirmware GCodes were originally based on the information from the RepRap wiki GCode page. There are GCodes for all supported control and configuration inputs along with status and debugging information. RepRapFirmware follows the philosophy of "GCode everywhere", in essence the users or external program's interaction with the firmware should be through GCodes. This page describes the RepRapFirmware supported GCodes. GCodes are a widely used machine control language. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |